PDXTI DT Swiss 240s OS 12-15mm TA Conversion

PDXTI DT Swiss 240s OS 12-15mm TA Conversion

65.00

PDXTI DT Swiss 240 End Caps, combined with the extremely light weight PDXTI 12-15-TA Adapter, allow the use of a 20mm x 110mm or 15mm x 100mm DT Swiss 240 hub with a 12mm x 100mm thru axle Road/CX/Gravel fork.
Includes end caps and adapter only. 12mm Thru Axle not included.

Add To Cart

PDXTI DT Swiss 240 End Caps, combined with the extremely light weight PDXTI 12-15-TA Adapter, allow the use of a 20mm x 110mm or 15mm x 100mm DT Swiss 240 hub with a 12mm x 100mm thru axle Road/CX/Gravel fork.

A specific known compatibility issue is the DT Swiss 240s 20x110mm Thru Axle front hub (MPN: H240BDEXR32SA1788S), which converts to standard 100mm width in 15mm or QR configurations only, with no existing 12mm end cap available.

The end caps for DT Swiss 15x100mm Thru Axle have an OD of 21mm at the fork interface end, which most 12mm forks will not accommodate.

Our DT Swiss 240s 12mm-Compatible 15mm end caps solve this problem and make the most versatile 240s hub even more so.

 
 

DT SWISS 240s END CAPS
- DT Swiss Part Number: HWGXXX00S4470S.
- Thread-in end caps convert 240s 20x110mm front hub to 15x100mm.
- Fits DT Swiss 240s 20x110mm Thru Axle Hubs #H240BDEXR32SA1788S.
- (Same compatibility as DT # HWYXXX00S2477S, without knurled insert.)

DIRECTIONS:
1) Swap end caps: use two wrenches to unthread (anti-clockwise) existing end caps from axle. NOTE: It is not uncommon for only one side to break free and thread off, requiring the axle to be pulled out and secured in a soft jawed vise to remove the second cap.)
2) Thread PDXTI DT Swiss 240 15mm End Caps caps on to axle.
2) Slide 12-15-TA Adapter into the 15mm hub.
3) Install wheel into fork as normal.
4) Install 12mm thru axle as normal.

NOTES: 
- A thin layer of high quality grease on the outside of the adapter and the outside of the 12mm thru axle are recommended for ease of assembly and to provide an extra moisture barrier.

- Compatible with all 12mm x 100mm forks.

- Compatible with DT Swiss 240s 20x110mm Thru Axle Hubs #H240BDEXR32SA1788S hubs; please note that the critical hub dimension is the OD of the end cap, which must be 20mm or smaller. Stock DT Swiss 240s 15x100mm end caps are 21mm OD.

- Thru axles provide compression of the fork ends where the hub end caps interface with the fork ends. Because all hubs and forks are manufactured by third parties to differing tolerances, to ensure an interference-free fit with all possible combinations the length of the PDXTI 12-15-TA Adapter is just under 100mm.